Multi-zone system General Airstage V-III AJG216LALBHH

The VRF system V-III series TM FUJITSU is a large multi-zone system that effectively air-conditions the air in multi-story buildings , and in private homes. Laconic and modern design, wide model range with performance from 8 to 54 hp. in increments of 2 hp, the ability to connect up to 64 indoor units. The total performance of connected indoor units of the VRF series V-III TM FUJITSU system is up to 150%.

The highest COP level for any combination of units is achieved by a set of unique technologies, such as a special heat exchanger design, a powerful DC-inverter compressor, and a powerful large-diameter fan. Due to the longest pipe line length in its class of 1000 m, as well as the length of the route from the first splitter to the most distant indoor unit - up to 90 m, the FUJITSU TM VRF system is easy to design and select for any building layout.

High static pressure of 82 Pa makes it possible to connect an additional air vent to the outdoor unit. This allows you to install outdoor units in technical rooms of high-rise buildings. A comfortable indoor climate is maintained even during oil return, as the system continues to operate.

• Excellent Energy SavingsInverter Heat Pump: High energy savings in both cooling and heating with All DC inverter technology to maximize seasonal efficiency.
• Easy installation and maintenanceEasy connections and flexible communication between devices make our installations and their maintenance easy to operate, even in large ground-based systems.
• High static pressure 82 PaThe outdoor unit can have an air exhaust duct with a static pressure of up to 82 Pa. This allows the outdoor unit to be installed inside the machine room and be able to carry out exhaust.
• Advanced Operation ControlWhen the units are connected to each other, the different compressors operate in a complex manner. Efficiency is significantly increased by operating the rotary compressor at low speeds, distributing the force.
• Perfect heat exchanger controlThe heat exchanger is divided into 2 parts: upper and lower. Heat transfer efficiency is improved by optimally managing the refrigerant, which is distributed to the top of the heat exchanger where the incoming air flow is greater.

Maximum efficiency of each operation

All our combinations have maximum manufacturability and efficient consumption thanks to our
energy coefficients.Some benefits are possible thanks to our exclusive air access design to the heat exchanger, our highly efficient DC Twin Rotary compressor and our innovative design that increases the effective exchange surface by up to 1.7 times.